|
|
Crown XLS602 Amplifier
The XLS Series of power amplifiers from Crown represents a new era in affordable, quality power amplification. The line consists of four models in a uniform, rugged 2U chassis, incorporating the best of tried-and-true design principles and innovative features.
XLS Series amplifiers are professional stereo power amplifiers engineered to meet demanding audio requirementsreliably and within budget. Plus, every XLS Series amplifier is backed by Crowns unequaled Three-Year, No-Fault, Fully-Transferable Warranty that covers everything. With over five decades of experience designing and building rock-solid products, Crown is the standard in amp technology. So check out the affordable, Crown XLS Series. They are a powerful argument for quality and value!
XLS602 Amplifier Features
Reliable design incorporates many popular features Housed in a rugged, all-steel 2U chassis Efficient forced-air fans prevent excessive thermal buildup Electronically balanced XLR inputs; touchproof binding post and Speakonฎ outputs Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel. Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications Technical Description The following applies to units in Stereo mode with 8-ohm loads unless otherwise specified. Performance 380W @ 8 ohms stereo 600W @ 4 ohms stereo 1200W @ 8 ohms bridged Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V. Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, 0.8 dB. Signal-to-Noise Ratio (20 Hz to 20 kHz) A-weighted, below rated power: >98 dB. No weighting, below rated power: >93 dB. Total Harmonic Distortion (THD): 200. Crosstalk (below rated power) at 1 kHz: 76 dB. at 20 kHz: 58 dB. Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced. Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono. AC Line Voltage and Frequency Configurations Available (ฑ10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC Controls Level: Two front-panel rotary level controls, one for each channel. Power: Front-panel switch; on when in the IN position. Circuit Breaker: Back-panel breaker provides overload protection. Mode Switch: Back-panel switch selects Dual or Bridge-Mono mode. Indicators Signal Presence Indicators: Two green LEDs, one for each channel, illuminate when the channels input signal exceeds 40 dBu. Clip Indicators: Two red LEDs, one for each channel, illuminate when the channels output is being overdriven. Power Indicator: Blue LED indicates amplifier has been turned on and AC power is available. Fault Indicator: Two red LEDs illuminate when amplifier is in protect mode. Also illuminates briefly during normal power-up when amplifier is first switched on. Input/Output Input Connectors: One per channel; back-panel three-pin female XLR input connectors. Output Connectors: Two 4-Pole Speakonฎ Output Connectors accept 2-pole or 4-pole Speakon connectors. The top Speakon connector is wired for both channels so it can be used for bridge-mono wiring or for stereo wiring of two speakers to a single Speakon connector. One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept banana plugs.) Protection XLS Series amplifiers provide extensive protection and diagnostic capabilities, including output current limiting, DC protection, circuit breaker, and thermal protection. Construction Ventilation: Flow-through ventilation from front to back. Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation. Air Volume Requirements (per minute per unit): 80.15 ftณ (2.27 mณ). Dimensions: EIA Standard 19-inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-inch (8.9-cm) height and 15.2-inch (38.6-cm) depth. Weight Net Weight: 29.0 lb (13.2 kg) Shipping Weight: 34.0 lb (15.4 kg)
Crown XLS602 Amplifier Your review of the XLS602 Amplifier
Average rating:
6.9ฏ
|
|

Hot deals, lowest prices on all your pro audio gear and instruments. EU.MusicianUniversity.com
Crown Crown XLS402A Stereo Power Amplifier (400 Watts) Crown XLS202A Stereo Power Amplifier (200 Watts) Crown XLS602A Stereo Power Amplifier (600 Watts) Crown XLS202 Amplifier Crown XLS802 Power Amplifier Crown XLS602 Amplifier Crown
Add Comment or Question Write a review! XLS602 Amplifier
ListPrice:$ 757.00 Available the US for online order from: zZounds Price:$ 499.95
Buy Online Easy 30 day return policy Buying online is safe, secure.. guaranteed!
| |